This Robovac Sucks and Mops Like a Champ, Except in One Location

Under the vacuum, you can find split, double roller brushes (in a way similar to the brush system in Roborock models again), and it can suck 20,000 in the most powerful opponents. X50 ultra, at the same time, there are dual, rotary mop pads that can move away from the body to clean up the wall; Mop pads can only stay on the base during the vacuum-only tasks and stay. There is also a sweeper who has three brushes that can lead to helping the vacuum’s way to help. The bot, a Lidar Tower (withdraws on the bottom of low furniture), but also stretches the front to navigate.

X50 Ultra Build – Fill a clean reservoir, install the detergent and connect it, to scan the QR code under the robot’s hood, and you are required to install any firmware updates and then use your home cancer. The initial scan of my apartment was very quickly. X50 Ultra did not drive everywhere, so I missed some areas, but I managed to calculate each square leg. You need to call the rooms and spend a few minutes to make section lines between them, but it is paragraph for the course with Robovac.

For first cleaning, I chose the Cleanius mode with standard and most “smart” mode. I suggested that I started with an initial deep cleansing, which was a beautiful touch, but it did not quite affect me. For beginners, X50 Ultra, starting from my kitchen, starting from my kitchen (penalty), jumping in a few areas between them and driving up to the bedroom, driving in a wild way. Then he was thrown into the living room, etc. Inside the room, X50 was a kind of surrounding, sort of surrounding, spinning in circles and really moved to think. The pattern made on my carpet was just random. All vacuum took a total of 80 minutes long as the next most slowest vacuum Roborock Saros Z70), even in deepest cleansing modes. X50 Ultra was rating in a room for maximum power in the battery until the end of the battery was about 30% lower. This means that in a bigger house that can stop stopping and continue to clean the middle (or reduce the power of the suction).

X50 Ultra has missed a fair amount of dirt in the initial run. After drying the floor, the kitchen and the hallway still ended and the less bits and pieces were surprised and surprised by the pieces, I sent the robot to those areas, but this time in the maximum + vacuum power. Robovac is very loud in this mode, but managed to suck everything in the middle of the rooms. Unfortunately, the outside cleaning was a serious letud. The sweeper stretched his arm, just missed a ton of misses near the walls.

See X50 Ultra in Amazon

Dreame’s Robovac Moppinging is a very good job and was able to clean three ketchup stains in the stages of drying, as well as in some of the floor. Unfortunately, he still struggled to clean the edges. I would shed several juices in the place of the sink (a common place for liquid crashes) and adapted to the edge of a ground-based closet. Although the expandable mop pad is not reached, he did not go to all. I will say, although the moping movement is silent. Some mops in Roborock’s bots shout like the banshees. X50 Ultra was the quietest mop in a Robovac I tried.

In general, the recognition of the facility in the X50 Ultra is strong. Carefully pull the orange usb cable in Hardwood and evaded a white cord in a white carpet. The detection of his object is not always perfect in the white rug in the white rug in the white rug, I have to sink (it would be easiest to see) and release the vacuum brush (very easy, a little job). X50 managed to escape things like Ultra, Socks and Slippers, and often when they see them on the map, they tag them properly. X50 dreams that Ultra can recognize more than 200 objects, and you can automatically set it to take a photo if you want.

For the toughest test, goldfish crackers, pumpkin seeds, consisting of pistachi shells, consisting of decorating oats and oregano’s walls, but also around the walls of Oregano. It is mainly good news here. The X50 Ultra was a better one of the other Robovac, I tested in the areas where he reached. Almost all the bots are really fighting with pistachio shells and tend to drown them. This bot did not have a look, hardly and silent did not stay. He also did not suffer or rebuilt with goldfish or seeds with a common issue. The X50 Ultra even has a few oats hiding under my TV cabinet – there is another robovac another robovac that I have tried. The vacuum and spinning brush system performed incredibly well here.

X50 Ultra still suffered from the above-mentioned external issues. Cleaning along the walls was spotted (I used dried Oregano, so I could see the places where he left). Robovac is not suitable for both corners, almost always a little debris (sometimes more). If a piece of a piece was in an inch or a furniture or a wall, it just missed him completely. I put several shells under the floods of the cabinet (able to undergo) and the bot also missed them. X50 Ultra is especially annoying because he performs better than other vacuums on the open floor.

There are some other excellent features worth the attention. For beginners, X50 Ultra, which is the biggest climbing for any Robovac on the market, it also stretches two clever stretches of two smart stretches of this kind of catapult. It’s nice to watch and worked well. X50 Ultra, there are also voice commands, so you can pair it with Google House, Apple Home or Alexa, you don’t need and very special commands (eg “kitchen” and so on.

I love that the X50 Ultra is throwing mop pads in the touch of the one that should help you dry your carpets. Even if you make both of them at once, Robovac will raise the most of 10.5mm (0.4 inches) to the above (0.4 inch), to keep the mop pads above. The bot can also reduce the LiDAR mast by making a height of about 3.5 inches. In general, the dreamer is a companion application, and with many polishes as Roborock applications, including POV video, sweep, sweeper, sweeper, sweeper, sweeper, sweeper, sweeper, etc.

As a result, the X50 Ultra is a very good robot vacuum / mop. Although more slowly than I want, the real thing that hinders him to be excellent with the capital G, is weak performance around the edges, corners and furniture. I will say, though, this seems to be limited by the apparatus, which is hoping that it can be solved in future firmware updates. However, for a robot vacuum, which is currently sold between $ 1,400 and $ 1,700, I do not have to empty / mop any edges after performing their main cleanliness.

See X50 Ultra in Amazon